Bu içerik şu anda orijinal dilinde mevcuttur.
Aydınlatma AksesuarlarıToptan satış sorgusu
Sero Bus Cable, 3 ft
Model / Ürün Kodu: 705140
Sero 3 ft Bus Cable for Modules on One Wall
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
Kaynak referans fiyatıTRY 595.51
Sadece karşılaştırma amaçlıdır. Güncel toptan fiyatınızı, stok durumunu ve teslimat koşullarını talep edin.
Ödeme gerekmiyor. İhtiyaçlarınız hakkında bir görüşme.
Fabrikadan doğrudan destek15 yılı aşkın deneyim
DAHA YAKINDAN BAKALIM
Bu ürün hakkında biraz daha bilgi
Sero 3 ft Bus Cable for Modules on One Wall
Product details
- Control gear rarely mounts in one row.
- A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
- This Sero cable covers those small gaps at 3 feet long.
- It reaches from one component to the next without leaving a large loop behind.
- That makes it a good fit for a single equipment board or a compact cabinet.
- That length gives some room to route around a bracket or conduit.
- Sero states that only its approved bus cables should connect system components.
- A matched cable keeps the system bus working the way it was designed.
- Each cable joins one unit to the next in the chain.
- Count the gaps between components to work out how many are needed.
- Measure along the planned route, not in a straight line, before choosing a length.
- Routing a Controller Cable Between Units
- Shut off power to the system before connecting or disconnecting any bus cable.
- Lay out the route so the cable follows walls, rails or cable trays.
- Fasten it every so often with soft ties, snug but not tight enough to pinch.
- Leave a small service loop near each connector so the plug never pulls taut.
- Push each connector home until it seats, then check that it stays put.
- Keep the cable away from heaters, ballasts and other hot equipment.
- Separate it from mains power lines where possible.
- Label both ends so the right module is easy to find later.
- Power the system back up and confirm each component reports to the controller.
- Check the run periodically for chafing where it crosses an edge.
- Swap out any cable with a damaged jacket or loose plug.
- 3 ft Length: Spans units on one wall or cabinet.
- Routing Room: Reaches around brackets and conduit.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Tidy Install: Little spare cable to coil.
Teknik Özellikler
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
Bunu projeniz için işe yarar hale getirelim.
Siparişinizde miktar, teslimat adresi, yetiştirme bölgesi ve varsa voltaj veya fiş gereksinimlerinizi belirtin. Özellikler, stok durumu, nakliye ve garanti koşulları yazılı teklifinizde teyit edilecektir.
Kaydedilen döviz kuru kullanılarak yapılan referans dönüşümü. 15 Kas 2026. Dönüştürülen tutarlar bir fiyat teklifi değildir.
KEŞFETMEYE DEVAM EDİN
Tüm ürünleri görüntüleMekanınız için daha fazla olanak
Aydınlatma Aksesuarları
Yield Lab Professional Series Double Ended Grow Light Reflector
Kaynak referansıTRY 3,271.75
Aydınlatma Aksesuarları
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
Kaynak referansıTRY 15,063.97
Aydınlatma Aksesuarları
Yield Lab Pro Series 120/220V 1000W Double Ended Complete Grow Light Kit
Kaynak referansıTRY 7,554.66
Sorular ve tartışma
Bir sorunuz mu var veya paylaşmak istediğiniz faydalı bir şey mi? Sohbeti başlatın.