Bu içerik şu anda orijinal dilinde mevcuttur.
Hidroponik ve SulamaToptan satış sorgusu
Dilution Solutions Micro-Doser - Etatron eOne MF Micro Dosing Pump Panel
Model / Ürün Kodu: 709171
Dilution Solutions Micro-Doser Built on the Etatron eOne MF
- Power supply
- 100 to 250 VAC, 50/60 Hz
- Line size
- 3/4 in or 1.5 in (by variant)
- Flow rate
- 1 L/h (0.26 GPH)
- Maximum pressure
- 10 bar (145 PSI)
Kaynak referans fiyatıTRY 79,992.71
Sadece karşılaştırma amaçlıdır. Güncel toptan fiyatınızı, stok durumunu ve teslimat koşullarını talep edin.
Ödeme gerekmiyor. İhtiyaçlarınız hakkında bir görüşme.
Fabrikadan doğrudan destek15 yılı aşkın deneyim
DAHA YAKINDAN BAKALIM
Bu ürün hakkında biraz daha bilgi
Dilution Solutions Micro-Doser Built on the Etatron eOne MF
Product details
- The Micro-Doser is an assembled injection panel built around the Etatron eOne MF 0110, a microprocessor diaphragm pump made for proportional dosing.
- A water meter on the panel reads flow in the main line, and the pump adds concentrate in step with it.
- The pump delivers up to 1 L/h, about 0.26 GPH, against as much as 10 bar (145 PSI).
- It runs up to 180 impulses per minute with an adjustable stroke, so the dose can sit at a fraction of a millilitre per gallon.
- A backlit graphic display handles the programming.
- The wetted path is built for concentrates, with a PVDF pump head, PTFE diaphragm, TFE/P seals and ceramic ball valves.
- The panel arrives plumbed on polyethylene board with the meter, check valve, pressure relief valve, injection valve, unions and a mixing chamber.
- Suction comes through a PVC tube with a foot filter, and separate PVC priming and polyethylene discharge tubes complete the kit.
- The pump accepts a 100 to 250 VAC supply at 50/60 Hz.
- Panels come in 3/4 in and 1.5 in line sizes, each in left-to-right or right-to-left flow.
- A tank is not included, so plan a container for the concentrate.
- Where a Micro Dosing Pump Fits in a Fertigation Room
- Super-concentrated additives are the usual job, the bottles whose label rate sits below what a typical water-powered injector meters well.
- Mount the panel on a wall close to the irrigation header, with the flow arrow matching the direction water travels.
- That is why orientation matters, since each panel is plumbed for one flow direction across the wall.
- Prime the pump through the priming tube before the first run, so no air sits in the head.
- Keep the foot filter off the bottom of the concentrate tank, where sediment settles.
- The pressure relief valve protects the line if a downstream valve closes while the pump is still stroking.
- Flush the head and injection valve with clean water when switching products.
- The honest limit is volume.
- At about a litre an hour it is made for small, potent doses, not for base nutrients.
- Heavy feed belongs on a larger injector, with this panel layered on top for the expensive bottle.
- Etatron eOne MF 0110 Pump: A microprocessor diaphragm pump doses in proportion to the water meter reading.
- 1 L/h at 10 bar: Output suits super-concentrated additives on a pressurized fertigation line.
- Adjustable Stroke: Up to 180 impulses per minute with stroke control holds very low dose rates.
- Chemical-Resistant Wetted Parts: PVDF head, PTFE diaphragm, TFE/P seals and ceramic balls handle concentrates.
- Fully Plumbed Panel: Water meter, check, relief and injection valves, unions and a mixing chamber come assembled.
- Two Sizes, Two Directions: Choose a 3/4 in or 1.5 in line size in left-to-right or right-to-left flow.
Teknik Özellikler
- Flow rate
- 1 L/h (0.26 GPH)
- Maximum pressure
- 10 bar (145 PSI)
- Dosing frequency
- Up to 180 impulses per minute
- Power supply
- 100 to 250 VAC, 50/60 Hz
- Line size
- 3/4 in or 1.5 in (by variant)
- Flow direction
- Left to right or right to left (by variant)
- Option
- 0.75 in - (Left to Right), 0.75 in - (Right to Left), 1.5 in - (Right to Left), 1.5 in - (Left to Right)
Bunu projeniz için işe yarar hale getirelim.
Siparişinizde miktar, teslimat adresi, yetiştirme bölgesi ve varsa voltaj veya fiş gereksinimlerinizi belirtin. Özellikler, stok durumu, nakliye ve garanti koşulları yazılı teklifinizde teyit edilecektir.
Kaydedilen döviz kuru kullanılarak yapılan referans dönüşümü. 15 Kas 2026. Dönüştürülen tutarlar bir fiyat teklifi değildir.
KEŞFETMEYE DEVAM EDİN
Tüm ürünleri görüntüleMekanınız için daha fazla olanak
Hidroponik ve Sulama
Yield Lab 600W HPS+MH Cool Tube Hood Reflector Grow Light Kit
Kaynak referansıTRY 11,081.34
Hidroponik ve Sulama
Yield Lab 600W HPS+MH Air Cool Tube Reflector Digital Grow Light Kit
Kaynak referansıTRY 10,073.72
Hidroponik ve Sulama
Yield Lab 600w HPS Air Cool Tube Digital Dimming Grow Light Kit
Kaynak referansıTRY 9,569.90
Sorular ve tartışma
Bir sorunuz mu var veya paylaşmak istediğiniz faydalı bir şey mi? Sohbeti başlatın.