This is the checklist for the day your AutoPot arrives, before any pot gets filled. Every kit is built from the same small parts library in different counts: valves, trays, pots, root control, pipe, and fittings, plus a reservoir on any variant ordered with a tank. The tables below give the exact counts for each model family so you can tell a missing part from a spare.
Count AQUAvalve5s first: you get one per tray. An easy2grow tray holds two pots on a single valve.
Plastic pots come with a black and gold root control disc or sheet. Fabric pots come with a PotSock.
A 4-pot kit packs fittings for two layouts, so a few pieces are left over after setup. Keep them.
Growing media, drainage material, an air pump, and a tank stand are never in the box.
Pipe arrives as a coil that you cut to length at setup, not as pre-cut runs, so a short-looking kit usually isn't.
Kits built on the previous tray design ship one grommet in total, for the tank. Either count is correct for the tray in your box.
Counts come from AutoPot USA's instruction sheets and product pages. Sizes not shown follow the same pattern: per-tray parts scale with pot count, while fittings, taps, and pipe change with the layout and tank.
1Pot systems (3.9 gal square plastic pot)
The 4Pot PRO adds an AirBase Square, an AirDome kit, and a propagation lid for each pot. It does not include an air pump.
easy2grow (two 2.2 gal pots per tray)
XL systems (6.6 gal round plastic pot)
XL PRO kits add an AirBase Round, an AirDome kit, and a propagation dome for each pot.
GeoPot systems (3 or 5 gal fabric pot in an XL tray)
XXL systems (9 or 13 gal fabric pot)
Tray2Grow (one 43.9 x 16.1 inch tray)
No Tray2Grow kit includes a reservoir unless you ordered a tank variant.
Why a 4-pot kit has leftover fittings
Every 4-pot kit carries fittings for a single row of four (1x4) and for a 2x2 square, which is why it ships 2 cross connectors and 4 tees. Pick one layout from the plan view on your instruction sheet, and whatever that layout doesn't use goes in the parts drawer. The spare pieces fit any 3/8" line if you add trays later.
Root control goes in first, before any drainage layer or media. An AirBase or AirDome sits on top of the disc, never under it.
A drainage layer of 1 inch maximum: pH-stable clay pebbles, pea gravel, Growstones, or Perlite No. 3, or an AirBase instead. XXL fabric pots skip it.
Each AirDome needs 15 gph, so four domes need a 60 gph pump. PRO kits include the domes but not the pump.
AutoPot recommends monitoring pH, EC, and water temperature. Modules, No Tank kits, and the Tray2Grow Slim base kit also need a reservoir and filter.
Square fits 2.2 and 3.9 gal pots; Round fits 6.6 gal plastic and 3 to 5 gal fabric pots.
Seats under the AirBase's pop-out center to push air into the base of the root zone.
Sold singly by float, so you replace only the one that's worn.
3/8" black or Pro Blue in 10 ft or 50 ft, for runs longer than the coil in your kit.
A filter on the reservoir side and a sealed pipe connection. AutoPot says to always run a filter with the reservoir and recommends only official AutoPot fittings.
Older 1Pot, XL, and easy2grow trays, pots, and lids take the AQUAvalve5 and 3/8" pipe unchanged. An older 12.4 gal tank drilled for 1/4" pipe needs its hole widened for the 3/8" grommet; AutoPot recommends a step drill bit to 12.5 mm. The original valve and 1/4" fittings are still sold as spares.
AutoPot's own product pages say the discs and sheets still work gold face down. Don't tear down a planted pot to flip one; use the table above next run. That same flexibility is why some printed instruction sheets show a different face than the Grow Guide.
Within a tray family, yes. The 2.2 and 3.9 gal square pots fit both 1Pot and easy2grow trays, and the XL tray takes either the 6.6 gal round pot or a 3 or 5 gal GeoPot. Moving a fabric pot into an XL tray means swapping the disc for a PotSock Round.
Damage photos taken before setup make replacements faster.
How to size an AutoPot reservoirPick a tank that lasts as long between refills as you want it to.
Why your tray isn't cycling, and how to fix itSymptom by symptom, from a tray that never fills to one that floods.
How to set up AutoPot for your first runReservoir height, media, and the hand-watering window before you switch on.
Sorular ve tartışma
Bir sorunuz mu var veya paylaşmak istediğiniz faydalı bir şey mi? Sohbeti başlatın.