Данный контент в настоящее время доступен на языке оригинала.
Осветительные аксессуарыЗапрос на оптовую продажу
Sero Bus Cable, 1 ft
Модель / Артикул: 705135
Sero 1 ft Bus Cable for Side-by-Side Modules
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
Исходная справочная ценаRUB 974.30
Только для сравнения. Запросите актуальную оптовую цену, наличие товара и условия доставки.
Оплата не требуется. Обсуждение ваших потребностей.
Прямая заводская поддержкаБолее 15 лет опыта
БОЛЕЕ ПОДРОБНЫЙ ВЗГЛЯД
Немного подробнее об этом продукте
Sero 1 ft Bus Cable for Side-by-Side Modules
Product details
- A controller and its add-on modules talk to each other over a shared system bus.
- When two of those units mount next to each other, a long cable only adds clutter.
- This Sero cable spans just 1 foot.
- It bridges neighboring components on a panel, shelf or wall board.
- With so little length, there is no coil to tuck away behind the equipment.
- Short runs also leave less cable exposed to bumps, carts and spray.
- Sero states that only its approved bus cables should connect system components.
- Using the matched cable keeps the connection in line with what the system was designed for.
- Each cable links one component to the next.
- A row of modules needs one cable for every gap between them.
- Plan the layout so each pair of units sits close enough for this short span.
- Wiring a Sero System Panel with Short Links
- Mount the components first so the spacing is fixed before any cable goes in.
- Power the system down before plugging in or removing a bus cable.
- Seat each connector fully until it stops, then give it a light tug to confirm it holds.
- Keep the cable flat against the panel rather than looped in the air.
- Avoid bending it sharply right at the plug, where strain does the most damage.
- Label both ends when several modules share one board.
- Those labels save time later when a unit needs to come out for service.
- Keep bus cables apart from mains power wiring where the layout allows.
- Restore power and check that the controller sees every connected component.
- Inspect connectors during routine maintenance for dust, moisture or corrosion.
- Replace a cable that shows a cracked jacket or a loose plug.
- 1 ft Length: Links components mounted side by side.
- No Excess Slack: Keeps panels clean and tidy.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Less Exposure: Short run stays out of the way.
Технические характеристики
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
Давайте это используем в вашем проекте.
В запросе укажите необходимое количество, место доставки, регион выращивания, а также требуемое напряжение и тип вилки. Технические характеристики, наличие, условия доставки и гарантии будут подтверждены в вашем письменном предложении.
Конвертация с использованием сохраненного обменного курса на определенную дату. 15 нояб. 2026 г.. Указанные суммы в пересчете не являются ценовым предложением.
ПРОДОЛЖАЙТЕ ИССЛЕДОВАТЬ
Посмотреть все товарыБольше возможностей для вашего пространства
Осветительные аксессуары
Yield Lab Professional Series Double Ended Grow Light Reflector
ИсточникRUB 5,352.87
Осветительные аксессуары
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
ИсточникRUB 24,645.97
Осветительные аксессуары
Yield Lab Pro Series 120/220V 1000W Double Ended Complete Grow Light Kit
ИсточникRUB 12,360.08
Вопросы и обсуждение
У вас есть вопрос или что-то полезное, чем вы хотите поделиться? Начните разговор.