Данный контент в настоящее время доступен на языке оригинала.
Гидропоника и орошениеЗапрос на оптовую продажу
Dilution Solutions Micro-Doser - Etatron eOne MF Micro Dosing Pump Panel
Модель / Артикул: 709171
Dilution Solutions Micro-Doser Built on the Etatron eOne MF
- Power supply
- 100 to 250 VAC, 50/60 Hz
- Line size
- 3/4 in or 1.5 in (by variant)
- Flow rate
- 1 L/h (0.26 GPH)
- Maximum pressure
- 10 bar (145 PSI)
Исходная справочная ценаRUB 130,875.06
Только для сравнения. Запросите актуальную оптовую цену, наличие товара и условия доставки.
Оплата не требуется. Обсуждение ваших потребностей.
Прямая заводская поддержкаБолее 15 лет опыта
БОЛЕЕ ПОДРОБНЫЙ ВЗГЛЯД
Немного подробнее об этом продукте
Dilution Solutions Micro-Doser Built on the Etatron eOne MF
Product details
- The Micro-Doser is an assembled injection panel built around the Etatron eOne MF 0110, a microprocessor diaphragm pump made for proportional dosing.
- A water meter on the panel reads flow in the main line, and the pump adds concentrate in step with it.
- The pump delivers up to 1 L/h, about 0.26 GPH, against as much as 10 bar (145 PSI).
- It runs up to 180 impulses per minute with an adjustable stroke, so the dose can sit at a fraction of a millilitre per gallon.
- A backlit graphic display handles the programming.
- The wetted path is built for concentrates, with a PVDF pump head, PTFE diaphragm, TFE/P seals and ceramic ball valves.
- The panel arrives plumbed on polyethylene board with the meter, check valve, pressure relief valve, injection valve, unions and a mixing chamber.
- Suction comes through a PVC tube with a foot filter, and separate PVC priming and polyethylene discharge tubes complete the kit.
- The pump accepts a 100 to 250 VAC supply at 50/60 Hz.
- Panels come in 3/4 in and 1.5 in line sizes, each in left-to-right or right-to-left flow.
- A tank is not included, so plan a container for the concentrate.
- Where a Micro Dosing Pump Fits in a Fertigation Room
- Super-concentrated additives are the usual job, the bottles whose label rate sits below what a typical water-powered injector meters well.
- Mount the panel on a wall close to the irrigation header, with the flow arrow matching the direction water travels.
- That is why orientation matters, since each panel is plumbed for one flow direction across the wall.
- Prime the pump through the priming tube before the first run, so no air sits in the head.
- Keep the foot filter off the bottom of the concentrate tank, where sediment settles.
- The pressure relief valve protects the line if a downstream valve closes while the pump is still stroking.
- Flush the head and injection valve with clean water when switching products.
- The honest limit is volume.
- At about a litre an hour it is made for small, potent doses, not for base nutrients.
- Heavy feed belongs on a larger injector, with this panel layered on top for the expensive bottle.
- Etatron eOne MF 0110 Pump: A microprocessor diaphragm pump doses in proportion to the water meter reading.
- 1 L/h at 10 bar: Output suits super-concentrated additives on a pressurized fertigation line.
- Adjustable Stroke: Up to 180 impulses per minute with stroke control holds very low dose rates.
- Chemical-Resistant Wetted Parts: PVDF head, PTFE diaphragm, TFE/P seals and ceramic balls handle concentrates.
- Fully Plumbed Panel: Water meter, check, relief and injection valves, unions and a mixing chamber come assembled.
- Two Sizes, Two Directions: Choose a 3/4 in or 1.5 in line size in left-to-right or right-to-left flow.
Технические характеристики
- Flow rate
- 1 L/h (0.26 GPH)
- Maximum pressure
- 10 bar (145 PSI)
- Dosing frequency
- Up to 180 impulses per minute
- Power supply
- 100 to 250 VAC, 50/60 Hz
- Line size
- 3/4 in or 1.5 in (by variant)
- Flow direction
- Left to right or right to left (by variant)
- Option
- 0.75 in - (Left to Right), 0.75 in - (Right to Left), 1.5 in - (Right to Left), 1.5 in - (Left to Right)
Давайте это используем в вашем проекте.
В запросе укажите необходимое количество, место доставки, регион выращивания, а также требуемое напряжение и тип вилки. Технические характеристики, наличие, условия доставки и гарантии будут подтверждены в вашем письменном предложении.
Конвертация с использованием сохраненного обменного курса на определенную дату. 15 нояб. 2026 г.. Указанные суммы в пересчете не являются ценовым предложением.
ПРОДОЛЖАЙТЕ ИССЛЕДОВАТЬ
Посмотреть все товарыБольше возможностей для вашего пространства
Гидропоника и орошение
Yield Lab 600W HPS+MH Cool Tube Hood Reflector Grow Light Kit
ИсточникRUB 18,130.04
Гидропоника и орошение
Yield Lab 600W HPS+MH Air Cool Tube Reflector Digital Grow Light Kit
ИсточникRUB 16,481.48
Гидропоника и орошение
Yield Lab 600w HPS Air Cool Tube Digital Dimming Grow Light Kit
ИсточникRUB 15,657.20
Вопросы и обсуждение
У вас есть вопрос или что-то полезное, чем вы хотите поделиться? Начните разговор.