Uma forma mais inteligente de crescer. Venda por atacado direto da fábrica. Mais de 15 anos de crescente experiência

Este conteúdo está disponível atualmente em seu idioma original.

Acessórios de iluminaçãoConsulta de atacado

Sero Bus Cable, 3 ft

Modelo / SKU: 705140

Sero 3 ft Bus Cable for Modules on One Wall

Type
System bus cable
Length
3 ft
Compatibility
Sero System
Preço de referência da fonteEUR 10.71

Apenas para fins de comparação. Solicite seu preço de atacado atual, disponibilidade e condições de entrega.

Nenhum pagamento é necessário. Uma conversa sobre o que você precisa.

Suporte direto da fábricaMais de 15 anos de experiência
UMA ANÁLISE MAIS DETALHADA

Um pouco mais sobre este produto

Sero 3 ft Bus Cable for Modules on One Wall

Product details

  • Control gear rarely mounts in one row.
  • A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
  • This Sero cable covers those small gaps at 3 feet long.
  • It reaches from one component to the next without leaving a large loop behind.
  • That makes it a good fit for a single equipment board or a compact cabinet.
  • That length gives some room to route around a bracket or conduit.
  • Sero states that only its approved bus cables should connect system components.
  • A matched cable keeps the system bus working the way it was designed.
  • Each cable joins one unit to the next in the chain.
  • Count the gaps between components to work out how many are needed.
  • Measure along the planned route, not in a straight line, before choosing a length.
  • Routing a Controller Cable Between Units
  • Shut off power to the system before connecting or disconnecting any bus cable.
  • Lay out the route so the cable follows walls, rails or cable trays.
  • Fasten it every so often with soft ties, snug but not tight enough to pinch.
  • Leave a small service loop near each connector so the plug never pulls taut.
  • Push each connector home until it seats, then check that it stays put.
  • Keep the cable away from heaters, ballasts and other hot equipment.
  • Separate it from mains power lines where possible.
  • Label both ends so the right module is easy to find later.
  • Power the system back up and confirm each component reports to the controller.
  • Check the run periodically for chafing where it crosses an edge.
  • Swap out any cable with a damaged jacket or loose plug.
  • 3 ft Length: Spans units on one wall or cabinet.
  • Routing Room: Reaches around brackets and conduit.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Tidy Install: Little spare cable to coil.

Especificações

Type
System bus cable
Length
3 ft
Compatibility
Sero System

Vamos fazer isso funcionar para o seu projeto.

Inclua a quantidade desejada, o local de entrega, a região de cultivo e quaisquer requisitos de voltagem ou tipo de plugue em sua solicitação. As especificações, a disponibilidade, os termos de envio e a garantia serão confirmados em seu orçamento por escrito.

Conversão de referência usando a taxa de câmbio salva com a data 15 de nov. de 2026. Os valores convertidos não constituem uma cotação.

VAMOS CRESCER JUNTOS

Perguntas e discussão

0

Tem alguma pergunta ou algo útil para compartilhar? Inicie a conversa.

CONTINUE EXPLORANDO

Mais possibilidades para o seu espaço

Ver todos os produtos
O INÍCIO DE ALGO BOM

Vamos dar visibilidade ao seu projeto.

Conte-nos um pouco sobre suas necessidades. Usaremos suas informações para preparar uma proposta de atacado adequada.

Sua lista de produtos

Sem pagamento. Sem compromisso. Apenas uma conversa útil.