A brighter way to grow. Factory-direct wholesale. 15+ years of growing expertise
Lighting AccessoriesWholesale inquiry

Sero Bus Cable, 3 ft

Model / SKU: 705140

Sero 3 ft Bus Cable for Modules on One Wall

Type
System bus cable
Length
3 ft
Compatibility
Sero System
Source reference priceUSD 11.82

For comparison only. Request your current wholesale price, availability and delivery terms.

No payment required. A conversation about what you need.

Factory-direct support15+ years of experience
A CLOSER LOOK

A little more about this product

Sero 3 ft Bus Cable for Modules on One Wall

Product details

  • Control gear rarely mounts in one row.
  • A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
  • This Sero cable covers those small gaps at 3 feet long.
  • It reaches from one component to the next without leaving a large loop behind.
  • That makes it a good fit for a single equipment board or a compact cabinet.
  • That length gives some room to route around a bracket or conduit.
  • Sero states that only its approved bus cables should connect system components.
  • A matched cable keeps the system bus working the way it was designed.
  • Each cable joins one unit to the next in the chain.
  • Count the gaps between components to work out how many are needed.
  • Measure along the planned route, not in a straight line, before choosing a length.
  • Routing a Controller Cable Between Units
  • Shut off power to the system before connecting or disconnecting any bus cable.
  • Lay out the route so the cable follows walls, rails or cable trays.
  • Fasten it every so often with soft ties, snug but not tight enough to pinch.
  • Leave a small service loop near each connector so the plug never pulls taut.
  • Push each connector home until it seats, then check that it stays put.
  • Keep the cable away from heaters, ballasts and other hot equipment.
  • Separate it from mains power lines where possible.
  • Label both ends so the right module is easy to find later.
  • Power the system back up and confirm each component reports to the controller.
  • Check the run periodically for chafing where it crosses an edge.
  • Swap out any cable with a damaged jacket or loose plug.
  • 3 ft Length: Spans units on one wall or cabinet.
  • Routing Room: Reaches around brackets and conduit.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Tidy Install: Little spare cable to coil.

Specifications

Type
System bus cable
Length
3 ft
Compatibility
Sero System

Let’s make it work for your project

Include your quantity, delivery destination, growing area and any voltage or plug requirements in your inquiry. Specifications, availability, shipping and warranty terms are confirmed in your written quotation.

LET’S GROW TOGETHER

Questions & discussion

0

Have a question or something useful to share? Start the conversation.

KEEP EXPLORING

More possibilities for your space

View all products
THE START OF SOMETHING GOOD

Let’s bring your project to light.

Tell us a little about what you need. We’ll use your details to prepare a relevant wholesale response.

Your product list

No payment. No obligation. Just a helpful conversation.