Jaśniejszy sposób na rozwój. Sprzedaż hurtowa bezpośrednio z fabryki. Ponad 15 lat rosnącego doświadczenia

Ta treść jest obecnie dostępna w oryginalnym języku.

Akcesoria oświetlenioweZapytanie hurtowe

Sero Bus Cable, 1 ft

Model / SKU: 705135

Sero 1 ft Bus Cable for Side-by-Side Modules

Type
System bus cable
Length
1 ft
Compatibility
Sero System
Cena referencyjna źródłaPLN 47.19

Tylko do celów porównawczych. Zapytaj o aktualną cenę hurtową, dostępność i warunki dostawy.

Brak opłat. Rozmowa o tym, czego potrzebujesz.

Wsparcie bezpośrednio od producentaPonad 15 lat doświadczenia
BLIŻSZE SPOJRZENIE

Trochę więcej o tym produkcie

Sero 1 ft Bus Cable for Side-by-Side Modules

Product details

  • A controller and its add-on modules talk to each other over a shared system bus.
  • When two of those units mount next to each other, a long cable only adds clutter.
  • This Sero cable spans just 1 foot.
  • It bridges neighboring components on a panel, shelf or wall board.
  • With so little length, there is no coil to tuck away behind the equipment.
  • Short runs also leave less cable exposed to bumps, carts and spray.
  • Sero states that only its approved bus cables should connect system components.
  • Using the matched cable keeps the connection in line with what the system was designed for.
  • Each cable links one component to the next.
  • A row of modules needs one cable for every gap between them.
  • Plan the layout so each pair of units sits close enough for this short span.
  • Wiring a Sero System Panel with Short Links
  • Mount the components first so the spacing is fixed before any cable goes in.
  • Power the system down before plugging in or removing a bus cable.
  • Seat each connector fully until it stops, then give it a light tug to confirm it holds.
  • Keep the cable flat against the panel rather than looped in the air.
  • Avoid bending it sharply right at the plug, where strain does the most damage.
  • Label both ends when several modules share one board.
  • Those labels save time later when a unit needs to come out for service.
  • Keep bus cables apart from mains power wiring where the layout allows.
  • Restore power and check that the controller sees every connected component.
  • Inspect connectors during routine maintenance for dust, moisture or corrosion.
  • Replace a cable that shows a cracked jacket or a loose plug.
  • 1 ft Length: Links components mounted side by side.
  • No Excess Slack: Keeps panels clean and tidy.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Less Exposure: Short run stays out of the way.

Specyfikacje

Type
System bus cable
Length
1 ft
Compatibility
Sero System

Sprawmy, żeby to zadziałało w Twoim projekcie

W zapytaniu ofertowym prosimy o podanie ilości, miejsca dostawy, obszaru uprawy oraz wszelkich wymagań dotyczących napięcia lub wtyczki. Specyfikacja, dostępność, warunki wysyłki i gwarancji zostaną potwierdzone w pisemnej ofercie.

Przeliczenie referencyjne przy użyciu zapisanego kursu wymiany z dnia 15 lis 2026. Przeliczone kwoty nie stanowią oferty handlowej.

ROŚNIJMY RAZEM

Pytania i dyskusja

0

Masz pytanie lub chcesz się czymś podzielić? Rozpocznij rozmowę.

KONTYNUUJ ODKRYWANIE

Więcej możliwości dla Twojej przestrzeni

Zobacz wszystkie produkty
POCZĄTEK CZEGOŚ DOBREGO

Rzućmy światło na Twój projekt.

Powiedz nam trochę o swoich potrzebach. Wykorzystamy Twoje dane, aby przygotować odpowiednią odpowiedź hurtową.

Twoja lista produktów

Bez opłat. Bez zobowiązań. Tylko pomocna rozmowa.