이 콘텐츠는 현재 원어로 제공됩니다.
조명 액세서리도매 문의
Sero Bus Cable, 3 ft
모델/SKU: 705140
Sero 3 ft Bus Cable for Modules on One Wall
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
출처 참조 가격KRW 15,792
비교 목적으로만 사용하십시오. 현재 도매 가격, 재고 여부 및 배송 조건을 문의하십시오.
결제는 필요하지 않습니다. 필요한 사항에 대해 이야기 나눠보세요.
공장 직송 지원15년 이상의 경력
자세히 살펴보기
이 제품에 대해 좀 더 자세히 알아보겠습니다.
Sero 3 ft Bus Cable for Modules on One Wall
Product details
- Control gear rarely mounts in one row.
- A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
- This Sero cable covers those small gaps at 3 feet long.
- It reaches from one component to the next without leaving a large loop behind.
- That makes it a good fit for a single equipment board or a compact cabinet.
- That length gives some room to route around a bracket or conduit.
- Sero states that only its approved bus cables should connect system components.
- A matched cable keeps the system bus working the way it was designed.
- Each cable joins one unit to the next in the chain.
- Count the gaps between components to work out how many are needed.
- Measure along the planned route, not in a straight line, before choosing a length.
- Routing a Controller Cable Between Units
- Shut off power to the system before connecting or disconnecting any bus cable.
- Lay out the route so the cable follows walls, rails or cable trays.
- Fasten it every so often with soft ties, snug but not tight enough to pinch.
- Leave a small service loop near each connector so the plug never pulls taut.
- Push each connector home until it seats, then check that it stays put.
- Keep the cable away from heaters, ballasts and other hot equipment.
- Separate it from mains power lines where possible.
- Label both ends so the right module is easy to find later.
- Power the system back up and confirm each component reports to the controller.
- Check the run periodically for chafing where it crosses an edge.
- Swap out any cable with a damaged jacket or loose plug.
- 3 ft Length: Spans units on one wall or cabinet.
- Routing Room: Reaches around brackets and conduit.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Tidy Install: Little spare cable to coil.
명세서
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
프로젝트에 도움이 되도록 만들어 봅시다.
문의 시 수량, 배송지, 재배 지역, 전압 또는 플러그 요구 사항을 포함해 주십시오. 사양, 재고 여부, 배송 및 보증 조건은 서면 견적서에서 확인하실 수 있습니다.
저장된 환율을 사용한 참조 변환 (날짜 기준) 2026. 11. 15.. 환산된 금액은 견적이 아닙니다.
계속 탐험하세요
모든 제품 보기당신의 공간을 위한 더 많은 가능성
조명 액세서리
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
출처 참조KRW 399,481
질문 및 토론
궁금한 점이 있거나 유용한 정보를 공유하고 싶으신가요? 대화를 시작해 보세요.