이 콘텐츠는 현재 원어로 제공됩니다.
조명 액세서리도매 문의
Sero Bus Cable, 1 ft
모델/SKU: 705135
Sero 1 ft Bus Cable for Side-by-Side Modules
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
출처 참조 가격KRW 15,792
비교 목적으로만 사용하십시오. 현재 도매 가격, 재고 여부 및 배송 조건을 문의하십시오.
결제는 필요하지 않습니다. 필요한 사항에 대해 이야기 나눠보세요.
공장 직송 지원15년 이상의 경력
자세히 살펴보기
이 제품에 대해 좀 더 자세히 알아보겠습니다.
Sero 1 ft Bus Cable for Side-by-Side Modules
Product details
- A controller and its add-on modules talk to each other over a shared system bus.
- When two of those units mount next to each other, a long cable only adds clutter.
- This Sero cable spans just 1 foot.
- It bridges neighboring components on a panel, shelf or wall board.
- With so little length, there is no coil to tuck away behind the equipment.
- Short runs also leave less cable exposed to bumps, carts and spray.
- Sero states that only its approved bus cables should connect system components.
- Using the matched cable keeps the connection in line with what the system was designed for.
- Each cable links one component to the next.
- A row of modules needs one cable for every gap between them.
- Plan the layout so each pair of units sits close enough for this short span.
- Wiring a Sero System Panel with Short Links
- Mount the components first so the spacing is fixed before any cable goes in.
- Power the system down before plugging in or removing a bus cable.
- Seat each connector fully until it stops, then give it a light tug to confirm it holds.
- Keep the cable flat against the panel rather than looped in the air.
- Avoid bending it sharply right at the plug, where strain does the most damage.
- Label both ends when several modules share one board.
- Those labels save time later when a unit needs to come out for service.
- Keep bus cables apart from mains power wiring where the layout allows.
- Restore power and check that the controller sees every connected component.
- Inspect connectors during routine maintenance for dust, moisture or corrosion.
- Replace a cable that shows a cracked jacket or a loose plug.
- 1 ft Length: Links components mounted side by side.
- No Excess Slack: Keeps panels clean and tidy.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Less Exposure: Short run stays out of the way.
명세서
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
프로젝트에 도움이 되도록 만들어 봅시다.
문의 시 수량, 배송지, 재배 지역, 전압 또는 플러그 요구 사항을 포함해 주십시오. 사양, 재고 여부, 배송 및 보증 조건은 서면 견적서에서 확인하실 수 있습니다.
저장된 환율을 사용한 참조 변환 (날짜 기준) 2026. 11. 15.. 환산된 금액은 견적이 아닙니다.
계속 탐험하세요
모든 제품 보기당신의 공간을 위한 더 많은 가능성
조명 액세서리
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
출처 참조KRW 399,481
질문 및 토론
궁금한 점이 있거나 유용한 정보를 공유하고 싶으신가요? 대화를 시작해 보세요.