このコンテンツは現在、元の言語で提供されています。
照明アクセサリー卸売に関するお問い合わせ
Sero Bus Cable, 3 ft
モデル/SKU: 705140
Sero 3 ft Bus Cable for Modules on One Wall
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
出典参考価格JPY 1,889
参考情報としてのみご利用ください。現在の卸売価格、在庫状況、配送条件についてはお問い合わせください。
料金は一切不要です。お客様のニーズについてお話ししましょう。
工場直送サポート15年以上の経験
さらに詳しく見てみよう
この製品についてもう少し詳しく
Sero 3 ft Bus Cable for Modules on One Wall
Product details
- Control gear rarely mounts in one row.
- A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
- This Sero cable covers those small gaps at 3 feet long.
- It reaches from one component to the next without leaving a large loop behind.
- That makes it a good fit for a single equipment board or a compact cabinet.
- That length gives some room to route around a bracket or conduit.
- Sero states that only its approved bus cables should connect system components.
- A matched cable keeps the system bus working the way it was designed.
- Each cable joins one unit to the next in the chain.
- Count the gaps between components to work out how many are needed.
- Measure along the planned route, not in a straight line, before choosing a length.
- Routing a Controller Cable Between Units
- Shut off power to the system before connecting or disconnecting any bus cable.
- Lay out the route so the cable follows walls, rails or cable trays.
- Fasten it every so often with soft ties, snug but not tight enough to pinch.
- Leave a small service loop near each connector so the plug never pulls taut.
- Push each connector home until it seats, then check that it stays put.
- Keep the cable away from heaters, ballasts and other hot equipment.
- Separate it from mains power lines where possible.
- Label both ends so the right module is easy to find later.
- Power the system back up and confirm each component reports to the controller.
- Check the run periodically for chafing where it crosses an edge.
- Swap out any cable with a damaged jacket or loose plug.
- 3 ft Length: Spans units on one wall or cabinet.
- Routing Room: Reaches around brackets and conduit.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Tidy Install: Little spare cable to coil.
仕様
- Type
- System bus cable
- Length
- 3 ft
- Compatibility
- Sero System
あなたのプロジェクトに役立てましょう
お問い合わせの際は、数量、配送先、栽培地域、電圧やプラグに関するご要望を明記してください。仕様、在庫状況、配送条件、保証条件は、書面による見積書にてご確認いただけます。
保存された為替レートを使用した参照換算 2026/11/15. 換算された金額は見積もりではありません。
探検を続けよう
すべての商品を見る空間の可能性がさらに広がります
照明アクセサリー
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
出典元JPY 47,774
質問とディスカッション
質問や役立つ情報があれば、ぜひ共有してください。会話を始めましょう。