Un modo più luminoso per crescere. Vendita all'ingrosso direttamente dalla fabbrica. Oltre 15 anni di esperienza in continua crescita

Questo contenuto è attualmente disponibile nella sua lingua originale.

Accessori per l'illuminazioneRichiesta all'ingrosso

Sero Bus Cable, 3 ft

Modello / SKU: 705140

Sero 3 ft Bus Cable for Modules on One Wall

Type
System bus cable
Length
3 ft
Compatibility
Sero System
Prezzo di riferimento della fonteEUR 10.71

Solo a scopo comparativo. Richiedete il vostro prezzo all'ingrosso aggiornato, la disponibilità e le condizioni di consegna.

Nessun pagamento richiesto. Una conversazione per capire di cosa hai bisogno.

Assistenza diretta dalla fabbricaOltre 15 anni di esperienza
UNO SGUARDO PIÙ ATTENTO

Qualche informazione in più su questo prodotto

Sero 3 ft Bus Cable for Modules on One Wall

Product details

  • Control gear rarely mounts in one row.
  • A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
  • This Sero cable covers those small gaps at 3 feet long.
  • It reaches from one component to the next without leaving a large loop behind.
  • That makes it a good fit for a single equipment board or a compact cabinet.
  • That length gives some room to route around a bracket or conduit.
  • Sero states that only its approved bus cables should connect system components.
  • A matched cable keeps the system bus working the way it was designed.
  • Each cable joins one unit to the next in the chain.
  • Count the gaps between components to work out how many are needed.
  • Measure along the planned route, not in a straight line, before choosing a length.
  • Routing a Controller Cable Between Units
  • Shut off power to the system before connecting or disconnecting any bus cable.
  • Lay out the route so the cable follows walls, rails or cable trays.
  • Fasten it every so often with soft ties, snug but not tight enough to pinch.
  • Leave a small service loop near each connector so the plug never pulls taut.
  • Push each connector home until it seats, then check that it stays put.
  • Keep the cable away from heaters, ballasts and other hot equipment.
  • Separate it from mains power lines where possible.
  • Label both ends so the right module is easy to find later.
  • Power the system back up and confirm each component reports to the controller.
  • Check the run periodically for chafing where it crosses an edge.
  • Swap out any cable with a damaged jacket or loose plug.
  • 3 ft Length: Spans units on one wall or cabinet.
  • Routing Room: Reaches around brackets and conduit.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Tidy Install: Little spare cable to coil.

Specifiche

Type
System bus cable
Length
3 ft
Compatibility
Sero System

Facciamo in modo che funzioni per il tuo progetto

Nella tua richiesta, specifica la quantità, l'indirizzo di consegna, la zona di coltivazione e qualsiasi esigenza relativa a voltaggio o spina. Specifiche, disponibilità, spedizione e termini di garanzia saranno confermati nel preventivo scritto.

Conversione di riferimento utilizzando il tasso di cambio salvato datato 15 nov 2026. Gli importi convertiti non costituiscono un preventivo.

CRESCIAMO INSIEME

Domande e discussione

0

Hai una domanda o qualcosa di utile da condividere? Avvia la conversazione.

CONTINUA A ESPLORARE

Maggiori possibilità per il tuo spazio

Visualizza tutti i prodotti
L'INIZIO DI QUALCOSA DI BUONO

Diamo vita al tuo progetto.

Descrivici brevemente le tue esigenze. Utilizzeremo i tuoi dati per preparare un'offerta all'ingrosso personalizzata.

Il tuo elenco prodotti

Nessun compenso. Nessun obbligo. Solo una conversazione utile.