Un modo più luminoso per crescere. Vendita all'ingrosso direttamente dalla fabbrica. Oltre 15 anni di esperienza in continua crescita

Questo contenuto è attualmente disponibile nella sua lingua originale.

Accessori per l'illuminazioneRichiesta all'ingrosso

Sero Bus Cable, 1 ft

Modello / SKU: 705135

Sero 1 ft Bus Cable for Side-by-Side Modules

Type
System bus cable
Length
1 ft
Compatibility
Sero System
Prezzo di riferimento della fonteEUR 10.71

Solo a scopo comparativo. Richiedete il vostro prezzo all'ingrosso aggiornato, la disponibilità e le condizioni di consegna.

Nessun pagamento richiesto. Una conversazione per capire di cosa hai bisogno.

Assistenza diretta dalla fabbricaOltre 15 anni di esperienza
UNO SGUARDO PIÙ ATTENTO

Qualche informazione in più su questo prodotto

Sero 1 ft Bus Cable for Side-by-Side Modules

Product details

  • A controller and its add-on modules talk to each other over a shared system bus.
  • When two of those units mount next to each other, a long cable only adds clutter.
  • This Sero cable spans just 1 foot.
  • It bridges neighboring components on a panel, shelf or wall board.
  • With so little length, there is no coil to tuck away behind the equipment.
  • Short runs also leave less cable exposed to bumps, carts and spray.
  • Sero states that only its approved bus cables should connect system components.
  • Using the matched cable keeps the connection in line with what the system was designed for.
  • Each cable links one component to the next.
  • A row of modules needs one cable for every gap between them.
  • Plan the layout so each pair of units sits close enough for this short span.
  • Wiring a Sero System Panel with Short Links
  • Mount the components first so the spacing is fixed before any cable goes in.
  • Power the system down before plugging in or removing a bus cable.
  • Seat each connector fully until it stops, then give it a light tug to confirm it holds.
  • Keep the cable flat against the panel rather than looped in the air.
  • Avoid bending it sharply right at the plug, where strain does the most damage.
  • Label both ends when several modules share one board.
  • Those labels save time later when a unit needs to come out for service.
  • Keep bus cables apart from mains power wiring where the layout allows.
  • Restore power and check that the controller sees every connected component.
  • Inspect connectors during routine maintenance for dust, moisture or corrosion.
  • Replace a cable that shows a cracked jacket or a loose plug.
  • 1 ft Length: Links components mounted side by side.
  • No Excess Slack: Keeps panels clean and tidy.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Less Exposure: Short run stays out of the way.

Specifiche

Type
System bus cable
Length
1 ft
Compatibility
Sero System

Facciamo in modo che funzioni per il tuo progetto

Nella tua richiesta, specifica la quantità, l'indirizzo di consegna, la zona di coltivazione e qualsiasi esigenza relativa a voltaggio o spina. Specifiche, disponibilità, spedizione e termini di garanzia saranno confermati nel preventivo scritto.

Conversione di riferimento utilizzando il tasso di cambio salvato datato 15 nov 2026. Gli importi convertiti non costituiscono un preventivo.

CRESCIAMO INSIEME

Domande e discussione

0

Hai una domanda o qualcosa di utile da condividere? Avvia la conversazione.

CONTINUA A ESPLORARE

Maggiori possibilità per il tuo spazio

Visualizza tutti i prodotti
L'INIZIO DI QUALCOSA DI BUONO

Diamo vita al tuo progetto.

Descrivici brevemente le tue esigenze. Utilizzeremo i tuoi dati per preparare un'offerta all'ingrosso personalizzata.

Il tuo elenco prodotti

Nessun compenso. Nessun obbligo. Solo una conversazione utile.