Ce contenu est actuellement disponible dans sa langue d'origine.
Sero Bus Cable, 1 ft
Modèle / UGS: 705135
Sero 1 ft Bus Cable for Side-by-Side Modules
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
À titre indicatif seulement. Veuillez nous contacter pour connaître nos tarifs de gros actuels, la disponibilité des produits et les conditions de livraison.
Aucun paiement requis. Une simple discussion pour comprendre vos besoins.
Un peu plus d'informations sur ce produit
Sero 1 ft Bus Cable for Side-by-Side Modules
Product details
- A controller and its add-on modules talk to each other over a shared system bus.
- When two of those units mount next to each other, a long cable only adds clutter.
- This Sero cable spans just 1 foot.
- It bridges neighboring components on a panel, shelf or wall board.
- With so little length, there is no coil to tuck away behind the equipment.
- Short runs also leave less cable exposed to bumps, carts and spray.
- Sero states that only its approved bus cables should connect system components.
- Using the matched cable keeps the connection in line with what the system was designed for.
- Each cable links one component to the next.
- A row of modules needs one cable for every gap between them.
- Plan the layout so each pair of units sits close enough for this short span.
- Wiring a Sero System Panel with Short Links
- Mount the components first so the spacing is fixed before any cable goes in.
- Power the system down before plugging in or removing a bus cable.
- Seat each connector fully until it stops, then give it a light tug to confirm it holds.
- Keep the cable flat against the panel rather than looped in the air.
- Avoid bending it sharply right at the plug, where strain does the most damage.
- Label both ends when several modules share one board.
- Those labels save time later when a unit needs to come out for service.
- Keep bus cables apart from mains power wiring where the layout allows.
- Restore power and check that the controller sees every connected component.
- Inspect connectors during routine maintenance for dust, moisture or corrosion.
- Replace a cable that shows a cracked jacket or a loose plug.
- 1 ft Length: Links components mounted side by side.
- No Excess Slack: Keeps panels clean and tidy.
- Sero Approved: Matched to Sero System components.
- One Link per Gap: Connects one unit to the next.
- Less Exposure: Short run stays out of the way.
Caractéristiques
- Type
- System bus cable
- Length
- 1 ft
- Compatibility
- Sero System
Faisons en sorte que cela fonctionne pour votre projet.
Veuillez indiquer la quantité, le lieu de livraison, la zone de culture et toute exigence en matière de tension ou de prise dans votre demande. Les spécifications, la disponibilité, les modalités d'expédition et de garantie seront confirmées dans votre devis écrit.
Conversion de référence utilisant le taux de change enregistré à la date 15 nov. 2026. Les montants convertis ne constituent pas une cotation.
Plus de possibilités pour votre espace
Yield Lab Professional Series Double Ended Grow Light Reflector
Yield Lab Professional Series 120/220v 630w Dual Bulb CMH Open Wing Reflector/Ballast
Yield Lab Pro Series 120/220V 1000W Double Ended Complete Grow Light Kit
Questions et discussion
Vous avez une question ou quelque chose d'utile à partager ? Lancez la conversation.