Dieser Inhalt ist derzeit in seiner Originalsprache verfügbar.
Titan Controls CO2 Regulator
Modell / Artikelnummer: 702710
Titan Controls CO2 Regulator for Tank-Fed Grow Rooms
- Flow Range
- 0.5-15 SCFH
- Compatible Controls
- Any 120 volt CO2 controller or timer
- Tank Pressure Gauge
- Shows how much CO2 is left in the cylinder.
- Controller Compatible
- Atlas CO2 controllers, Apollo timers and wall timers.
Nur zum Vergleich. Fordern Sie Ihren aktuellen Großhandelspreis, die Verfügbarkeit und die Lieferbedingungen an.
Keine Zahlung erforderlich. Ein Gespräch über Ihre Bedürfnisse.
Noch ein paar weitere Informationen zu diesem Produkt
Titan Controls CO2 Regulator for Tank-Fed Grow Rooms
Product details
- Enriching a sealed room with bottled CO2 starts at the tank, and this regulator is the piece that meters the gas out.
- Titan Controls item 702710 combines a tank pressure gauge, a flowmeter and a heavy-duty 120 volt solenoid in one body.
- The flowmeter reads from 0.5 to 15 standard cubic feet per hour, set with a brass flow adjustment knob.
- A ball rises and falls inside the clear tube, so the flow rate is visible at a glance.
- The solenoid opens only when it receives power, which lets a controller or timer decide when CO2 flows.
- That makes it compatible with any 120 volt CO2 controller or timer, including Titan's Atlas monitor/controllers and Apollo repeat cycle timers.
- With an Atlas controller, gas runs whenever the room drops below the PPM set point.
- With a timer, the regulator opens at set intervals based on room volume and flow rate.
- Titan's instructions include a timing chart for raising a room by about 1,100 to 1,200 PPM, to roughly 1,500 PPM total.
- For rooms over 2,000 cubic feet, the sheet gives a simple formula for working out run time.
- Installing a CO2 Regulator With Solenoid on the Tank
- Before connecting, crack the tank valve open for about 3 seconds to blow out any debris, then close it.
- Seat one of the white plastic washers inside the large brass nut to prevent leaks.
- Tighten the nut with a crescent wrench, not pliers, and do not hold the plastic flowmeter while tightening.
- Skip pipe thread tape and lubricants on the tank connection.
- Run the 1/4 in tubing from the barbed fitting to the back of an oscillating fan, which helps spread CO2 around the room.
- Open the flow knob about half a turn before opening the tank, then open the tank valve 2 or 3 turns.
- Check every connection with soapy water for leaks.
- Set the flow with the brass knob.
- Never open it so far that the ball passes the top of the scale, since that can freeze the regulator.
- Run CO2 only while the lights are on, and keep room levels below 2,500 PPM.
- Titan covers the regulator against material defects for 1 year, and replacement washers are item 702712.
- 0.5-15 SCFH Flowmeter: Visible ball indicator with a brass adjustment knob.
- 120V Solenoid: Opens only when the controller or timer powers it.
- Tank Pressure Gauge: Shows how much CO2 is left in the cylinder.
- Controller Compatible: Atlas CO2 controllers, Apollo timers and wall timers.
- Timing Chart Included: Run times by room volume and flow setting.
- Technical Specifications
Spezifikationen
- Flow Range
- 0.5-15 SCFH
- Compatible Controls
- Any 120 volt CO2 controller or timer
- Tank Pressure Gauge
- Shows how much CO2 is left in the cylinder.
- Controller Compatible
- Atlas CO2 controllers, Apollo timers and wall timers.
Lass es uns für dein Projekt zum Laufen bringen
Bitte geben Sie in Ihrer Anfrage die gewünschte Menge, den Lieferort, die Anbaufläche sowie eventuelle Spannungs- oder Steckeranforderungen an. Spezifikationen, Verfügbarkeit, Versand- und Garantiebedingungen werden in Ihrem schriftlichen Angebot bestätigt.
Referenzumrechnung unter Verwendung des gespeicherten Wechselkurses vom 15.11.2026. Die umgerechneten Beträge stellen kein Angebot dar.
Mehr Möglichkeiten für Ihren Raum
Yield Lab 6 inch 440 CFM Duct Inline Fan with 6" Carbon Filter Ducting and Clamps
Yield Lab 6 Inch 440 CFM Charcoal Filter and Duct Fan Combo Kit
Fragen und Diskussion
Haben Sie eine Frage oder möchten Sie etwas Nützliches teilen? Starten Sie das Gespräch.