Ein vielversprechenderer Weg zum Wachstum. Großhandel direkt ab Werk. Mehr als 15 Jahre wachsende Expertise

Dieser Inhalt ist derzeit in seiner Originalsprache verfügbar.

BeleuchtungszubehörGroßhandelsanfrage

Sero Bus Cable, 3 ft

Modell / Artikelnummer: 705140

Sero 3 ft Bus Cable for Modules on One Wall

Type
System bus cable
Length
3 ft
Compatibility
Sero System
QuellenreferenzpreisEUR 10.71

Nur zum Vergleich. Fordern Sie Ihren aktuellen Großhandelspreis, die Verfügbarkeit und die Lieferbedingungen an.

Keine Zahlung erforderlich. Ein Gespräch über Ihre Bedürfnisse.

Direkter WerkssupportMehr als 15 Jahre Erfahrung
EIN GENAUERER BLICK

Noch ein paar weitere Informationen zu diesem Produkt

Sero 3 ft Bus Cable for Modules on One Wall

Product details

  • Control gear rarely mounts in one row.
  • A sensor module may sit above the controller, or a relay unit may hang a short way down the wall.
  • This Sero cable covers those small gaps at 3 feet long.
  • It reaches from one component to the next without leaving a large loop behind.
  • That makes it a good fit for a single equipment board or a compact cabinet.
  • That length gives some room to route around a bracket or conduit.
  • Sero states that only its approved bus cables should connect system components.
  • A matched cable keeps the system bus working the way it was designed.
  • Each cable joins one unit to the next in the chain.
  • Count the gaps between components to work out how many are needed.
  • Measure along the planned route, not in a straight line, before choosing a length.
  • Routing a Controller Cable Between Units
  • Shut off power to the system before connecting or disconnecting any bus cable.
  • Lay out the route so the cable follows walls, rails or cable trays.
  • Fasten it every so often with soft ties, snug but not tight enough to pinch.
  • Leave a small service loop near each connector so the plug never pulls taut.
  • Push each connector home until it seats, then check that it stays put.
  • Keep the cable away from heaters, ballasts and other hot equipment.
  • Separate it from mains power lines where possible.
  • Label both ends so the right module is easy to find later.
  • Power the system back up and confirm each component reports to the controller.
  • Check the run periodically for chafing where it crosses an edge.
  • Swap out any cable with a damaged jacket or loose plug.
  • 3 ft Length: Spans units on one wall or cabinet.
  • Routing Room: Reaches around brackets and conduit.
  • Sero Approved: Matched to Sero System components.
  • One Link per Gap: Connects one unit to the next.
  • Tidy Install: Little spare cable to coil.

Spezifikationen

Type
System bus cable
Length
3 ft
Compatibility
Sero System

Lass es uns für dein Projekt zum Laufen bringen

Bitte geben Sie in Ihrer Anfrage die gewünschte Menge, den Lieferort, die Anbaufläche sowie eventuelle Spannungs- oder Steckeranforderungen an. Spezifikationen, Verfügbarkeit, Versand- und Garantiebedingungen werden in Ihrem schriftlichen Angebot bestätigt.

Referenzumrechnung unter Verwendung des gespeicherten Wechselkurses vom 15.11.2026. Die umgerechneten Beträge stellen kein Angebot dar.

LASST UNS GEMEINSAM WACHSEN

Fragen und Diskussion

0

Haben Sie eine Frage oder möchten Sie etwas Nützliches teilen? Starten Sie das Gespräch.

WEITER ERKUNDEN

Mehr Möglichkeiten für Ihren Raum

Alle Produkte ansehen
DER BEGINN VON ETWAS GUTEM

Lass uns dein Projekt ans Licht bringen.

Schildern Sie uns kurz Ihre Anforderungen. Wir nutzen Ihre Angaben, um Ihnen ein passendes Angebot für den Großhandel zu unterbreiten.

Ihre Produktliste

Keine Zahlung. Keine Verpflichtung. Nur ein hilfreiches Gespräch.