Ein vielversprechenderer Weg zum Wachstum. Großhandel direkt ab Werk. Mehr als 15 Jahre wachsende Expertise

Dieser Inhalt ist derzeit in seiner Originalsprache verfügbar.

Hydroponik & BewässerungGroßhandelsanfrage

Dilution Solutions Micro-Doser - Etatron eOne MF Micro Dosing Pump Panel

Modell / Artikelnummer: 709171

Dilution Solutions Micro-Doser Built on the Etatron eOne MF

Power supply
100 to 250 VAC, 50/60 Hz
Line size
3/4 in or 1.5 in (by variant)
Flow rate
1 L/h (0.26 GPH)
Maximum pressure
10 bar (145 PSI)
QuellenreferenzpreisEUR 1,438.48

Nur zum Vergleich. Fordern Sie Ihren aktuellen Großhandelspreis, die Verfügbarkeit und die Lieferbedingungen an.

Keine Zahlung erforderlich. Ein Gespräch über Ihre Bedürfnisse.

Direkter WerkssupportMehr als 15 Jahre Erfahrung
EIN GENAUERER BLICK

Noch ein paar weitere Informationen zu diesem Produkt

Dilution Solutions Micro-Doser Built on the Etatron eOne MF

Product details

  • The Micro-Doser is an assembled injection panel built around the Etatron eOne MF 0110, a microprocessor diaphragm pump made for proportional dosing.
  • A water meter on the panel reads flow in the main line, and the pump adds concentrate in step with it.
  • The pump delivers up to 1 L/h, about 0.26 GPH, against as much as 10 bar (145 PSI).
  • It runs up to 180 impulses per minute with an adjustable stroke, so the dose can sit at a fraction of a millilitre per gallon.
  • A backlit graphic display handles the programming.
  • The wetted path is built for concentrates, with a PVDF pump head, PTFE diaphragm, TFE/P seals and ceramic ball valves.
  • The panel arrives plumbed on polyethylene board with the meter, check valve, pressure relief valve, injection valve, unions and a mixing chamber.
  • Suction comes through a PVC tube with a foot filter, and separate PVC priming and polyethylene discharge tubes complete the kit.
  • The pump accepts a 100 to 250 VAC supply at 50/60 Hz.
  • Panels come in 3/4 in and 1.5 in line sizes, each in left-to-right or right-to-left flow.
  • A tank is not included, so plan a container for the concentrate.
  • Where a Micro Dosing Pump Fits in a Fertigation Room
  • Super-concentrated additives are the usual job, the bottles whose label rate sits below what a typical water-powered injector meters well.
  • Mount the panel on a wall close to the irrigation header, with the flow arrow matching the direction water travels.
  • That is why orientation matters, since each panel is plumbed for one flow direction across the wall.
  • Prime the pump through the priming tube before the first run, so no air sits in the head.
  • Keep the foot filter off the bottom of the concentrate tank, where sediment settles.
  • The pressure relief valve protects the line if a downstream valve closes while the pump is still stroking.
  • Flush the head and injection valve with clean water when switching products.
  • The honest limit is volume.
  • At about a litre an hour it is made for small, potent doses, not for base nutrients.
  • Heavy feed belongs on a larger injector, with this panel layered on top for the expensive bottle.
  • Etatron eOne MF 0110 Pump: A microprocessor diaphragm pump doses in proportion to the water meter reading.
  • 1 L/h at 10 bar: Output suits super-concentrated additives on a pressurized fertigation line.
  • Adjustable Stroke: Up to 180 impulses per minute with stroke control holds very low dose rates.
  • Chemical-Resistant Wetted Parts: PVDF head, PTFE diaphragm, TFE/P seals and ceramic balls handle concentrates.
  • Fully Plumbed Panel: Water meter, check, relief and injection valves, unions and a mixing chamber come assembled.
  • Two Sizes, Two Directions: Choose a 3/4 in or 1.5 in line size in left-to-right or right-to-left flow.

Spezifikationen

Flow rate
1 L/h (0.26 GPH)
Maximum pressure
10 bar (145 PSI)
Dosing frequency
Up to 180 impulses per minute
Power supply
100 to 250 VAC, 50/60 Hz
Line size
3/4 in or 1.5 in (by variant)
Flow direction
Left to right or right to left (by variant)
Option
0.75 in - (Left to Right), 0.75 in - (Right to Left), 1.5 in - (Right to Left), 1.5 in - (Left to Right)

Lass es uns für dein Projekt zum Laufen bringen

Bitte geben Sie in Ihrer Anfrage die gewünschte Menge, den Lieferort, die Anbaufläche sowie eventuelle Spannungs- oder Steckeranforderungen an. Spezifikationen, Verfügbarkeit, Versand- und Garantiebedingungen werden in Ihrem schriftlichen Angebot bestätigt.

Referenzumrechnung unter Verwendung des gespeicherten Wechselkurses vom 15.11.2026. Die umgerechneten Beträge stellen kein Angebot dar.

LASST UNS GEMEINSAM WACHSEN

Fragen und Diskussion

0

Haben Sie eine Frage oder möchten Sie etwas Nützliches teilen? Starten Sie das Gespräch.

WEITER ERKUNDEN

Mehr Möglichkeiten für Ihren Raum

Alle Produkte ansehen
DER BEGINN VON ETWAS GUTEM

Lass uns dein Projekt ans Licht bringen.

Schildern Sie uns kurz Ihre Anforderungen. Wir nutzen Ihre Angaben, um Ihnen ein passendes Angebot für den Großhandel zu unterbreiten.

Ihre Produktliste

Keine Zahlung. Keine Verpflichtung. Nur ein hilfreiches Gespräch.